Troubleshooting; Warranty - Snap-On BK6500 Manual De Instrucciones

Troubleshooting

SYMPTOM
Display Unit does not
display image from
imager handle
LCD screen is black,
but Display Unit is ON
Unit will not switch on
Battery does not hold
a charge
Units will not charge
LED on imager is ON
but no image
Image on display is
frozen
Charging LEDs flash
red/green
Charging LED glows
amber

Warranty

Limited Two (2) Year Warranty Snap-on Tools Company (the "Seller") warrants only to the original purchaser that under normal use, care and service,
the Equipment (except as otherwise provided herein) shall be free from defects in material and workmanship for two years from the date of original in-
voice. SELLER'S OBLIGATIONS UNDER THIS WARRANTY ARE LIMITED SOLELY TO THE REPAIR OR, AT SELLER'S OPTION,REPLACEMENT
OF EQUIPMENT OR PARTS WHICH TO SELLER'S SATISFACTION ARE DETERMINED TO BE DEFECTIVE AND WHICH ARE NECESSARY IN
SELLER'S JUDGMENT, TO RETURN THIS EQUIPMENT TO GOOD OPERATING CONDITION. NO OTHER WARRANTIES, EXPRESS OR IMPLIED
OR STATUTORY, INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, SHALL APPLY AND ALL SUCH WARRANTIES ARE HEREBY EXPRESSLY DISCLAIMED. This warranty does not cover (and separate
charges for parts, labor and related expenses shall apply to) any damage to, malfunctioning,in operability or improper operation of the Equipment
caused by, resulting from or attributable to (A) abuse, misuse or tampering;(B) alteration, modification or adjustment of the Equipment by other than
Seller's authorized representatives; (C) installation, repair or maintenance (other than specified operator maintenance) of the Equipment or related
equipment, attachments, peripherals or optional features by other than Seller's authorized representatives; (D) improper or negligent use,application,
operation, care, cleaning, storage or handling; (E) fire, water, wind, lightening or other natural causes; (F) adverse environmental conditions, including,
without limitation, excessive heat, moisture, corrosive elements, or dust or other air contaminants, radio frequency interference, electric power failure,
power line voltages beyond those specified for the Equipment, unusual physical, electrical or electromagnetic stress and/or other condition outside
of Seller's environmental specifications;(G) use of Equipment in combination or connection with other equipment, attachments, supplies or consum-
able not manufactured or supplied by Seller; or (H) failure to comply with any applicable federal, state or local regulation,requirement or specification
governing emission analyzers and related supplies or consumables. Repairs or replacements qualifying under this Warranty will be performed on
regular business days during Seller's normal working hours within a reasonable time following purchaser's request. All requests for Warranty service
must be made during the stated warranty period. This Warranty is nontransferable.
Digital Video Scope
POSSIBLE REASON
The imager is not inserted into the
imager handle
Video out cable is inserted
Battery is very low
Faulty battery
Power supply is not plugged in.
Battery is too hot
Broken video signal wire
Processor locked up
Faulty battery
Battery is low
Snap-on
SOLUTION
Connect imager securely to
imager handle
Remove cable
Charge unit until Green charge
LED illuminates.
Return unit to appropriate service
center location.
Connect power supply to AC
supply and to BK6500
Allow unit to cool
Test with second imager if
available. Return to appropriate
service center location
Cycle power
Return unit to appropriate service
center location.
Charge until Green LED illuminates
19