Bremont SOLO-32 Manual Del Usuario página 4

ChanGinG The STraP
RemovIng a stRap
Use the end of your watch tool
to carefully remove the spring bar
out of the case lug. Pressure should
be applied to the side of the strap
to reveal the spring bar, allowing
access for the pronged end of
the tool to sit over the flange of
the spring bar. Carefully depress
the spring bar to allow it to be
removed from the case lug.
FIttIng a stRap
Place the end of the spring bar into
one hole of the case lug and use the
end of the watch tool to depress
the spring bar allowing the other
end to locate into the opposite
hole. Slowly release and ensure that
the spring bar locates correctly into
the hole of the case lug.
SOLO-32
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. The mechanical movement with automatic winding has a
free-swinging rotor that keeps the mainspring wound via the motion of
your wrist. The movement in your SOLO-32 has 18 jewels, runs at 28,800
bph and has a 38-hour power reserve once fully wound. The watch is water
resistant to 50m (5ATM) and the dial is protected by a multi-layered anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
SCrew-dOwn CrOwn
Your SOLO-32 is fitted with a screw-down crown. To wind or to adjust
your watch this crown must be unscrewed in an anti-clockwise direction.
When turned in this direction the crown will move out to position I
automatically and allow you to wind the watch. Pulling the crown out
further will allow different operations to be performed as detailed
overleaf. When finished winding or adjusting the watch please ensure that
the crown is screwed back in by gently pushing and turning in a clockwise
direction until the crown comes to a stop.