Bremont MBIII Manual Del Usuario página 4

CHaNGING THE STRap
RemovIng a stRap
Use the end of your watch tool to
carefully lever the spring bar out
of the lug.
FIttIng a stRap
Place one end of the spring bar
into the hole in the lug and use the
end of the watch tool to lever the
other end into position.
MBIII
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. The mechanical movement with automatic winding has
a free-swinging rotor that keeps the mainspring wound via the motion
of your wrist. The movement in your MBIII has 21 jewels, runs at 28,800
bph and has a 42-hour power reserve once fully wound. The watch is
water resistant to 100m (10ATM) and the dial is protected by a dual anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WaTCH
Your MBIII can be wound from crown position I by rotating the crown in
a clockwise motion. The movement will automatically start with just a
few revolutions of the rotor, however it is better to wind the movement
fully with 30-40 revolutions of the crown. By doing this you will achieve
maximum accuracy and have a power reserve of 42-hours, even when the
watch is not on your wrist.