Low Battery Indication - AD Instruments True RMS AD9929 Manual De Usuario

_______________________________________________________________________________
Use button + & —to select serial number XXXX on the left upper corner and record data on
the right upper corner.
To finish above RECALL function, press EXIT button.
Parameter setting up SET
1 Press the RANGE button second seconds to enter into SET
function. Then press shortly once, change on setting content.
Setting content includes(in sequence)
A: upper limit buzzer alarm
B: lower limit buzzer alarm
C: auto power off time
D: turn off phonating
E: back lit time
Use ← + - → buttons to select the parameter
2 Press SET button continuously to switch to setting content, till exiting set up to testing mode.
So the updated setting content is saved. If press EXIT button in this period, all setting cann't
be saved.
AC+DC
In all the measuring mode VAC,mV(AC),10A(AC),mA(AC),uA(AC), press button EXIT for
2seconds to enters into AC+DC testing. The precision is the same as AC measure. LCD
shows AC+DC signal. Press button EXIT to exit.

LOW BATTERY INDICATION

When the icon appears alone in the display
Maintenance
WARNING: To avoid electric shock, disconnect the test leads from any source of voltage before removing the
back cover or the battery or fuse covers.
WARNING: To avoid electric shock, do not operate your meter until the battery and fuse covers are in place and
fastened securely.
This MultiMeter is designed to provide years of dependable service, if the following care instructions are performed:
1.
KEEP THE METER DRY. If it gets wet, wipe it off.
2.
USE AND STORE THE METER IN NORMAL TEMPERATURES. Temperature extremes can shorten the life
of the electronic parts and distort or melt plastic parts.
3.
HANDLE THE METER GENTLY AND CAREFULLY. Dropping it can damage the electronic parts or the case.
©Copyright Abacanto Digital SA.
, the battery should be replaced.
Manual de usuario AD9929
AD Instruments
45