Uline Н-2889 Instrucciones De Ensamble

H-2889
32 GALLON RECYCLED
ROUND RECEPTACLE
TOOLS NEEDED
Power Drill 7/16" Socket Bit
2" Hex Head Cap Bolt x 56
Flat Washer x 56
1/4" Tee Nut x 56
Figure 1
Recessed Holes
Face Out
33" Resinwood Slat
A
PAGE 1 OF 6
1-800-295-5510
uline.com
Hammer
(Optional)
PARTS
32" Resinwood Slat x 20
(With Two Holes)
33" Resinwood Slat x 4
(With Four Holes)
ASSEMBLY
1. Verify all parts are present before beginning.
2. Take the bottom ring and begin with one of the two
Bottom Ring
3. Place the 33" resinwood slat on outside of the bottom
4. Take 1/4" tee nuts and align with holes (prongs facing
Inside
of Ring
Pour le français, consulter les pages 5-6.
Bottom Ring x 1
Top Ring x 1
NOTE: Before starting, note that four resinwood
slats are longer (33") than the rest to lift can off the
ground. These must be evenly spaced apart with
shorter (32") slats between them.
longer 33" resinwood slats, which have two holes on top
and two on bottom of plank.
NOTE: The slats have a top and bottom. The top
edge is beveled, while the bottom edge is flat.
Recessed holes need to face outward.
ring. Place hex head cap bolts and washers through
the slat then through the pre-drilled holes in the bottom
resinwood ring.
NOTE: Tap screws into place with hammer if
difficult to push in.
into the inside of the bottom resinwood ring) and tighten.
(See Figure 1)
NOTE: Place round portion of the nut inside
pre-drilled holes on ring. (See Figure 1A) Apply
pressure to nut on inside ring while drilling bolt to
prevent nut from popping out.
NOTE: Do not over-tighten. User still must attach
resinwood slats to top ring.
Para Español, vea páginas 3-4.
32 Gallon Rigid Liner x 1
Lid x 1
0621 IH-2889