Uline Н-4290 Instrucciones De Ensamble página 3

2
Bottom End of Locker
2
First
Locker
Figure 2
Figure 3
PAGE 3 OF 12
1
Figure 1
Interior
Sides
4
5
7
6
ASSEMBLY
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back (1) on a protected flat surface so that
the flanges face upward.
2. Bolt side (2) to back (1) so that side flange fits
around back (use 8 bolts and nuts - nuts to the
inside). Do not use bottom two holes; these will be
used for attaching legs in step 8. (See Figure 1)
3. Next, bolt top (4) and bottom (4) to back and left
side panel (use 4 bolts and nuts each). Bolt shelf
(5) to left side panel (use 2 bolts and nuts). Bolt an
interior side and back panel to the flange on the
back of the first locker in ten places. (See Figure 2)
4. Next attach a top and bottom to the first interior
side and back. Bolt shelf to the first interior side.
These will share bolts with the parts on either side as
shown in detail view. (See Figure 2)
5. Next attach another interior side and back panel
to the flange on the back of the second locker.
Then attach remaining top, bottom and shelf to the
4
interior side. Attach top and bottom to the back.
(See Figure 2)
1
6. Bolt remaining side to the back so that side flange
fits around back. Attach side to top, bottom and
shelf. (See Figure 3)
7. Attach coat hooks (6 and 7) to each locker's left
and right side, back panel and ceiling:
• Side/Back – 1 single hook (6) on side and back of
each locker, 1st and 2nd holes below shelf.
• Ceiling – 1 double hook (7) on inside ceiling of
each locker.
NOTE: Hooks on interior sides will share bolts
and nuts with hooks in the locker next to it.
0321 IH-4290