Uline H-4440 Manual Del Usuario

H-4440
I-UNIT SLATWALL TOWER
TOOLS NEEDED
Phillips Screwdriver Rubber Mallet (Optional)
Confirmat Screw x 6
Wing Panel x 2 Camlock x 16
KICK BASE ASSEMBLY
1. Install camlock pins into the predrilled holes in kick
base boards using screwdriver. (See Figure 1)
2. Install camlocks into large holes in kick base boards
by tapping them into position with rubber mallet.
(See Figure 2)
NOTE: Ensure the hole in the side of the
camlock always faces outward.
3. Arrange kick base boards to form a square, so that
each corner has camlock pins set into the camlocks
of the adjacent board. (See Figure 3)
4. Connect camlocks and pins by inserting screwdriver
into the top hole of the camlock and turning
clockwise. (See Figure 4)
NOTE: Tilt screwdriver at an angle while twisting
to better lock the camlocks.
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Camlock Pin x 12 Pan Head Screw x 16
Screw Cap x 6
ASSEMBLY
Pour le français, consulter les pages 5-6.
Spinner Base Top x 1
Caster x 4 Kick Base Board x 4
Figure 1
Camlock Pin
Figure 2
Camlock
Figure 3
Para Español, vea páginas 3-4.
Center Panel x 1
Figure 4
0521 IH-4440