Setting Angle Of Air Flow - HTW IX39B-R32 Manual De Usuario

•

Setting Angle of Air Flow

Setting vertical angle of air flow
While the unit is on, use the SWING /
DIRECT button to set the direction (vertical
angle) of airflow.
1. Press the SWING /DIRECT button once
to activate the louver. Each time you
press the button, it will adjust the louver
by 6°. Press the button until the direction
you prefer is reached.
2. To make the louver swing up and down
continuously, press and hold the
SWING/DIRECT button for 3 seconds.
Press it again to stop the automatic
function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See Fig.2.3)
and manually adjust it to your preferred
direction. For some units, the horizontal angle
of the airflow can be set by remote control.
please refer to the Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not
set louver at too vertical an angle for long
periods of time. This can cause water to
condense on the louver blade, which will
drop on your floor or furnishings. (See Fig.
2.2)
When using COOL or HEAT mode,
setting the louver at too vertical an angle
can reduce the performance of the unit
due to restricted air flow.
Do not move louver by hand. This will cause
the louver to become out of sync. If this
occurs, turn off the unit and unplug it for a
few seconds, then restart the unit. This will
reset the louver.
Page 9


Caution: Do not keep louver at too
vertical an angle for long periods of
time. This can cause water
condensation to drip on your
furnishings.
Fig. 2.2
CAUTION
Do not put your fingers in or near the
blower and suction side of the unit. The
high-speed fan inside the unit may cause
injury.
Deflector rod
Fig. 2.3