Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE GENERATOR FROM
CARTON
•
Open top flaps of shipping carton.
•
Slice two corners at end of carton from top to
bottom so the panel can be folded down flat, then
remove all packing material.
•
Remove the generator and contents from the
shipping carton.
CARTON CONTENTS
Check all contents against those listed below:
•
Main unit
•
Engine oil
•
Owner's manual
•
Wheel Kit
If any parts are missing or damaged, call the
generator helpline at 1-800-222-3136.
INSTALL WHEEL KIT
NOTE: While the wheel kit is designed to greatly
improve the portability of your generator, it is not
intended for over-the-road use.
Handle
Mounting Leg
All manuals and user guides at all-guides.com
ASSEMBLY
Capscrew
Nut
Nut
You will need a socket wrench with 1/2" or 13mm
sockets, a 5/16" wrench and a needle-nose pliers to
install this kit.
Install the Wheel Kit as Follows:
1. Place bottom of generator cradle on a flat surface.
2. Place axle stud through wheel retainer on cradle
frame, as shown below.
3. Use 15/16" wrench to secure axle stud to frame
with 5/8-18 jam nut.
4. Install other axle stud in same manner.
NOTE: Be sure to install wheel with raised hub inboard.
5. Tip unit and install wheel. Place flat washer over
axle stud.
6. Retain wheel on axle stud with retaining pin.
Install other wheel on remaining axle stud the
same way.
7. Attach support leg using two 13mm wrenches with
20mm cap screws and lock nuts.
8. Center lifting handle on generator end of cradle.
Attach handle using two 13mm wrenches with
capscrews and hex nuts.
Jam Nut
Axle
Stud
Capscrew
Wheel
Retaining Pin
6
Washer
Publicidad
Capítulos
Tabla de contenido
