Setup Procedure - Mitsubishi Electric MDT42IS Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 89

Setup Procedure

1. Determine the installation location
CAUTION:
DO NOT ATTEMPT TO INSTALL THE LCD MONITOR BY
YOURSELF.
Installing your LCD display must be done by a qualifi ed tech-
nician. Contact your dealer for more information.
CAUTION:
MOVING OR INSTALLING THE LCD MONITOR MUST BE
DONE BY TWO OR MORE PEOPLE.
Failure to follow this caution may result in injury if the LCD
monitor falls.
CAUTION:
Do not mount or operate the display upside down or face
down.
CAUTION:
Do not install the LCD monitor where it will be exposed to
direct sunlight, as this will result in display defects.
CAUTION:
This LCD has a temperature sensor and cooling fan. If the
LCD becomes too hot, the cooling fan will turn on automati-
cally. If the LCD becomes overheated and the cooling fan
is running, the "Caution" menu will appear. If the "Caution"
menu appears, discontinue use and allow the unit to cool.
When the LCD monitor is used in an enclosure or with protec-
tion on LCD surface, please check the inside temperature of
monitor by "HEAT STATUS" (See page 31). The temperature is
too hot than normal condition, please set "cooling fan" to ON
on SCREEN SAVER function (See page 28).
IMPORTANT:
Lay the protective sheet, which was wrapped around the LCD
monitor when it was packaged, beneath the LCD monitor so
as not to scratch the panel.
2. Installing and removing the remote
control batteries
The remote control is powered by 1.5V AAA batteries.
To install or replace batteries:
How to install the batteries
1. Unlock and pull up the cover in the arrow's direction.
2. Align the batteries according to the (+) and (–) indications
inside the case.
3. Replace the cover.
How to remove the batteries
1. Unlock and pull up the cover in the arrow's direction.
2. Remove the batteries.
CAUTION:
Incorrect use of batteries can result in leaks or bursting.
Be careful especially about the following points.
All manuals and user guides at all-guides.com
NOTE:
If you do not intend to use the Remote Control for a long
period, remove the batteries.
3. Connect external equipment
4. Connect the supplied power cord
NOTE:
Please refer to "Safety Precautions, Maintenance &
Recommended Use" section of this manual for proper
selection of AC power cord.
5. Switch on the power of all the
When connected with a computer, switch on the power of the
computer fi rst.
English-10
Place "AAA" batteries matching the + and - signs on each
battery to the + and - signs of the battery compartment.
Do not mix battery types.
Do not combine new batteries with used ones. It causes
shorter battery life or leakage of batteries.
Remove dead batteries immediately to prevent battery
liquid from leaking into the battery compartment. Don't
touch exposed battery acid, it cause damage to your skin.
(See pages 15-19)
To protect the connected equipment, turn off the main
power before making connections.
Refer to your equipment user manual.
The power outlet socket should be installed as near to the
equipment as possible, and should be easily
accessible.
Fully insert the prongs into the power outlet socket.
Loose connection may cause noise.
Clamper
Use the clamper
to secure the
cable firmly.
attached external equipment

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dr854

Tabla de contenido