Uline Н-6313 Instrucciones De Ensamblaje página 3

NOTE: Before assembly, to avoid being locked
out of cabinet, remove the key for manual
entry from the battery compartment on the
back of the electronic lock.
ASSEMBLING CABINET
1. Place the back (1) on a protected surface. The
bottom flange should face upward.
2. Attach the left side (3) and right side (2) to the back
by placing flange around the back and bolting the
back and sides together with seven bolts and nuts
on each side. Be sure that the lances on all shelf
adjustment strips point in the same direction.
(See Figure 1)
NOTE: Do not use the bottom hole on each
side.
Figure 1
3. To help hold the sides in position, insert one shelf (4)
into the approximate center of the unit, inserting
the shelf edges into the lances on all four shelf
adjustment strips. Be sure the channeled edge of
the shelf is toward the cabinet front. (See Figure 2)
Figure 2
4
PAGE 3 OF 15
ASSEMBLY
3
1
2
4. Locate top (5), which has the holes along the perimeter.
Place top, with two holes toward front, under flanges
at top of sides. Secure with three bolts along each
side and five in back. (See Figure 3)
Figure 3
5. Place door and frame assembly (7) over body.
(See Figure 4)
NOTE: If having issues with doors aligning, it
may be due to cabinet not sitting level. Use
included nut driver to adjust leveling feet in
bottom front two corners. Nut driver should
insert through inside of cabinet down into feet
and adjust as needed.
Figure 4
7
6. Bolt sides to frame.
5
0321 IH-6313