Stryker M-1 Manual Del Usuario página 17

O O p p e e r r a a t t i i o o n n
O O p p e e r r a a t t i i n n g g t t h h e e c c o o t t f f a a s s t t e e n n e e r r
W W A A R R N N I I N N G G
• Do not allow untrained assistants to assist in the operation of the product.
• Always make sure that the cot is locked in the fastener before transporting the patient. Injury may occur if the cot is not
secure.
C C A A U U T T I I O O N N - - Improper usage of the product can cause injury to the patient or operator. Operate the product only as
described in this manual.
1. Before you operate the fastener, press the red release button (F) on the latch housing (G) to make sure that the latch is
in the released position (Figure 1).
2. Make sure that the foot end latch housing is between the loading wheels when you load the cot into the fastener.
N N o o t t e e - - The fastener guide rails (A) will center the head end of the cot (Figure 1).
3. Guide the cot into the vehicle or loading tray system until the rear latch post locks into the latch housing.
N N o o t t e e - - The foot end latch housing is equipped with a two-stage locking device (Figure 14). When the cot is locked in the
fastener, the red release button will return to its original position.
A
B
C
The Stryker Model 6373, 6376, and 6381 cot fastener systems are equipped with a two-stage locking device. In the unlikely
event the vehicle is involved in an accident, the two-stage locking device at the head end of the fastener will deploy to lock
the head end of the cot in the cot fastener system until you manually release the cot.
To release the cot from the two-stage locking device, pull both of the red release knobs (B) on the inside of the front
retaining hooks (C) (Figure 14).
6373-009-005 Rev F.0
A
B
F F i i g g u u r r e e 1 1 4 4 – – T T w w o o - - s s t t a a g g e e l l o o c c k k i i n n g g d d e e v v i i c c e e
C
A
Flipper
Red release knob
Front retaining hook
13 EN