Getting Started - Shark NV42 Manual De Instrucciones

Getting Started

a c e*
f
b
g
d
2
Along with your upright unit, you
Your Shark Navigator
will find the following components:
is easy to assemble:
a Vacuum Body 1
Lay your vacuum body on a
level surface.
b
Motorized Floor Brush
2 Slide the electrical connection
c Handle Assembly
from the motorized floor brush
d
Super Stretch Hose
into the main body to click into
place.
e Cleaning Wand
3 Connect the hose from the
f Pet Upholstery Tool
main body to the motorized
g
Cleaning Attachments
floor brush; push with a slight
turning motion to create a snug
fit.
4 TOLL FREE: 1-800-798-7398
4
5
3
7
4
® Upright Slide the handle assembly
into the upright unit aligning
the hose hook on the handle
assembly with the power cord
hooks on the back of the unit.
5
Secure the handle assembly in
place with the included bolt.
6 Place the vacuum in the upright
position.
7 Store the Crevice Tool, Dusting
Brush and Cleaning Wand on
the unit.
8
c
a
b
8 9
Attach the Super Stretch Hose: When storing your vacuum,
wind cord around the two cord
a)
Snap hose into swivel
holders and secure with cord
connector
clip:
b) Route under anti-tip hook
• Quick Cord release at the
c)
Route over upper hose
top of the unit – place in the
holder
upright position.
d) Press securely onto cleaning
• Second holder near the
wand
base – turn until it is pointing
down.
IMPORTANT:
To prevent vacuum from
To release the cord, turn the Quick
tipping, secure hose under the
Cord release to the left or right.
anti-tip hose hook.
IMPORTANT:
For suction to reach the
Motorized Floor Brush, the
Cleaning Wand and Super
Stretch Hose must be attached
securely on the vacuum body.
9
d
10
To carry the vacuum:
With the unit in the standing
position, lift by the Dust Cup
Assembly Handle (carry handle).
CAUTION: When lifting or
carrying, DO NOT press Dust
Cup Assembly release button.
www.sharkclean.com
English
5