BH FITNESS H9140 Manual Del Usuario página 5

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERY.
To fit the battery, remove the rear
cover on the monitor, Fig.1, and
carefully insert the "R-6" type battery
into the battery compartment making
sure that the battery's polarity is
correct (matching the battery's «+»
terminal with the «+» sign inside the
battery compartment, and the «-»
terminal with the «-» sign). Close the
cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the battery and
wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important:
components in special containers Fig.2.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time and calories
burnt. Press MODE to change from
one value to another.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
uses one 1.5 volt
Deposit electronic
of speed,
English
Pressing the RESET key with the
machine stopped will reset the value
shown in the screen.
Pressing the RESET key during 3
seconds with the machine stopped will
reset the values.
A. SCAN FUNCTION.-
In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
Press the MODE key and this will
cancel the SCAN function.
B.- TIME FUNCTION.-
This function counts up in steps of one
second to a maximum of 99:59
seconds.
C. SPEED FUNCTION.-
This function displays the speed in
km/h.
D. DISTANCE FUNCTION.-
This function counts up in steps of 0.1
km/ml, up to a maximum of 99.9
km/ml.
E. CALORIE FUNCTION.-
This function counts up in steps of 0.1
calorie, up to a maximum of 999.9
calories.
5
mode the computer