Replacing The Filters; Replacing The Solenoid Valve Cartridge; Replace The Thermal Element - Franke AT3O0039 Instrucciones De Montaje Y Uso

21. Replacing the filters

Water volume regulator filters
21.1 Remove the shower panel (see
21.2 Unscrew the locking screws (a) on the water volume regulators.
21.3 Replace the filters (b).
☞
Important!
Note the installation position of the filters.
21.4 Reassemble in reverse order.
Solenoid valve cartridge filter
21.5 Remove the solenoid valve cartridge (see
21.6 Use flat-nosed pliers to remove the filter (c).
21.7 Replace the filter.
☞
Important!
Note the installation position. The crosspiece of the filter may not be on top of the
flow hole.
21.8 Reassemble in reverse order.

22. Replacing the solenoid valve cartridge

22.1 Remove the shower panel (see
22.2 Loosen the cable connection between the solenoid valve cartridge and the
electronics module.
22.3 Loosen the screws (a).
22.4 Remove and replace the solenoid valve cartridge (b).
22.5 Reassemble in reverse order.

23. Replace the thermal element

Warning!
Set the scald protection after installing the fitting or removing the thermal element.
Failure to observe this instruction can result in injuries due to scalding.
23.1 Close the water volume regulators (see
23.2 Trigger the fitting.
23.3 Remove the temperature selector (see
23.4 Remove the screw (b)
Chapter 19.).
Chapter
Chapter 19.).
Work step
Chapter 16.).
- 12 -
22.).
12.23).