Installation Instructions - SysTech SY-VB10D Manual Del Usuario

Installation Instructions

Monitor Unit System
1. Raise the hanging buckle, remove the
battery cover (as shown in Figure 1), and
then put in the li-ion battery, make sure
the battery contacts are well connected
to the metal contact points on the
chassis, then close the battery cover.
2. Use the recommended transformer
(as shown in Figure 2), connect it
to the transformer outlet of the
vision system and the other end to
the power supply.
3. The system will automatically enter
into charging mode [the green display
indicator will automatically light up].
For rst use, charging mode shall be
maintained for at least 4 hours until the
completion of charging. If the monitor unit
system is closed, the monitor can also be
charged, the green display indicator will light up,
and it will put out after the charging is
completed.
4. Press ON/OFF button to start the monitor unit.
Placement Type
Raise the hanging buckle (as shown in Figure 3), and
then rotate the lock to x it.
All manuals and user guides at all-guides.com
4
Figure 1
Figure 2
Figure 3