Troubleshooting; Parts List - Craftsman 315.CR2000 Manual Del Operador

maintenance
 Insert the string into the anchor hole in the upper part of
the spool. Wind the string around the upper part of the
spool clockwise, as shown by the arrows on the spool.
Place string in the slot on upper spool flange, leaving
about 6 in. extended beyond the slot. do not overfill.
After winding the string, there should be at least 1/4 in.
between the wound string and the outside edge of the
spool.
 Replace the plastic retainer, spool, and the spool retainer.
Refer to Spool replacement earlier in this manual.

troUBleShooting

ProBlem PoSSiBle caUSe
String will not advance when using String is welded to itself.
the auto-feed head:
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Grass wraps around boom Cutting tall grass at ground
housing and string head level.
Motor fails to start when switch Battery is not secure.
trigger is depressed.
Battery is not charged.
All manuals and user guides at all-guides.com
Storing the trimmer
 Remove the battery pack from the string trimmer be-
fore storing.
 Clean all foreign material from the trimmer.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Replacement Spool Part Number .................... 3110382AG
Replacement Spool Cap Part Number ............. 3411546CG
SolUtion
lubricate with silicone spray.
Install more string. Refer to String replace-
ment earlier in this manual.
Pull string while pressing button.
Remove string from spool and rewind. Refer
to String replacement earlier in this man-
ual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latches on each side of the battery pack
snap into place.
Charge the battery pack according to the
instructions included with your model.
10 - english
craftSman 19.2 Volt String trimmer – model nUmBer 315.cr2000
The model number will be found on a label attached to the motor housing. Always mention the model
number in all correspondence regarding your String trimmer or when ordering repair parts.
See BacK Page for PartS ordering inStrUctionS
1
5
6
13
12
15
2
16
Key Part
no. number description
1 099932001902 logo label (Handle) .................. 2
2 3220313G Screw (M4 x 14 mm) .................. 3
3 31104349G Front Handle .............................. 1
4 3110282BG Knob (M6) .................................. 1
5 31104181AG Clamp ........................................ 1
6 3290205G Hex Nut (M6).............................. 1
7 099959001907 Warning label (Icon) .................. 1
8 3330182AG edger Guide............................... 1
9 099934001900 data label (left) ........................ 1
10 099934001901 data label (Right) ...................... 1
11 099934001903 Pivoting Head label .................. 1
12 31102349G Grass deflector Assembly ......... 1
3
1
4
7
10
11
9
8

PartS liSt

Key Part
no. number description
Qty.
13 099934001902 Auto line Feed label................. 1
15 3110382AG Spool w/line .............................. 1
16 3411546CG Spool Cap .................................. 1
not ShoWn
130279003 Battery ....................................... 1
130279005
130279007
103279008
1425301 Charger ...................................... 1
988000012 operator's Manual ..................... 1
11 - english
Qty.