G En Erator Adapter Cord Set - Troy-Bilt 030247 Manual Del Operario

Section 4: Operation
the Engine
(. Turn OFF and unplug a[( electrical loads from
generator pane( receptacles. NEVER start or stop engine
with electrical devices plugged in and turned ON.
2. Let engine run at no-load for several minutes to
stabilize internal temperatures of engine and generaton
3. Turn engine off according to instructions given in the
engine operator's manual.
4. Move fuel valve to "Off' position.
REC EPTACLES
CAUTION
•
NEVER
attempt to power a device requiring more amperage
than generator or receptacle can supply.
. DO NOT overload the generacon See"Don't Overload
(__enera_or _',
20/240 Volt AC, 30 Amp, Locking
Receptacle
Use a NEHA LI 4-30 plug with this receptacle. Connect a
4-wire cord set rated for 250VoltAC loads at 30Amps (or
greater) (Figure 7).You can use the same 4-wire cord if you
)lan to run a 120Volt load.
4-Wire Cord Set
/ \
(Neutral)
IIIIII
NEPIA LI4-30 f-)-7
Ground (Green)
This receptacle powers [20/240VoltAC, 60 Hz, single
phase loads requiring up to 7,200 watts of power (7.2 kW)
at 30 Amps for 240Volts or two independent 120Volt
loads at 30 Amps each.The outlet is protected by a 30 Amp
rocker switch circuit breaker.
120 Volt AC, 20 Amp, Duplex
Receptacles
Each duplex receptacle (Figure 8) is protected against
overload by a push-to-reset circuit breaker.
@
Use each receptacle to operate 120VoltAC, single-phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)
at 20 Amps of current. Use cord sets that are rated for
125 Volt AC loads at 20 Amps (or greater).
G EN ERATOR ADAPTER
CORD SET
The generator is equipped with a 25' generator adapter
cord set designed for a 240Volt, 30 Amp grounded neutral
circuit (Figure 9).
The maximum load on each outlet is [ 5 Amps.The
maximum total load on both yellow wire outlets or black
wire outlets is 30 Amps. Each outlet is protected by a
15 Amp fuse.
NOTE: Follow all safety precautions when connecting any
extension cord or device to the generator.
4@