Ducati PRO-II Plus Manual Del Usuario página 11

NOTICE
The vehicle is delivered folded and with the handlebar removed.
Steps:
1. Open the stand
2. Pick up the handlebar, place the lever in the closed position and lower the safety ring.
3. Install the handlebar on the rod
4. Install the hook (see photo) bringing it closer to the rod
and being careful to match the holes and insert the screws.
5. Insert the screw on the outside into the hole located under the control panel.
6. Tighten the screws.
7. Bring the plastic plate (see photo) close to the second hole/profile of the control panel,
match it up and then insert and tighten the screw.
8. Charge the battery to 100%
9. Adjust the folding mechanism**
10. Adjust the braking system (chapter 9)
11. Check the tyre pressure (44PSI)*.
*If the scooter has not travelled at least 60% of the stated km or reached the maximum
speed in the first 3 months of use, it is likely that the wheels have deflated again, it will
thus be necessary to restore the pressure as indicated (44PSI)
** If the lever is too soft when closing, tighten the front Allen screw just enough to
increase the safety grip.
6. Assembly and configuration
09