Brake Adjustment - Ducati PRO-II Plus Manual Del Usuario

9. Brake adjustment

Brake levers:
The position of the brake lever can be
adjusted if necessary through point A (see
photo).
A
Brake calliper adjustment:
C A
Brake caliper adjustment:
If the brake is too tight or too loose, use the
hex wrench to loosen the nut (A), then adjust
the brake cable, (shorten the brake cable
upwards if it is too tight, pull the brake cable
down if it is too loose) and then, retighten the D
nut (A). If, even after following the first step,
the brake is too loose or too tight it may be
necessary to adjust the brake pad (fixed) that
can be adjusted through the wheel on the
opposite side, using the hex wrench to move
the pad further away/closer (B) (see image).
Check the correct alignment between the B
brake caliper and the disc. Use screws C and D
to adjust the position / alignment on the disc
if necessary.
12