Nolan X-lite X-402 T Seguridad E Instrucciones página 17

ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base.
2.2 Insert the left front flap into the seat on the support fixed to the polystyrene inner
shell and push it slightly downwards until it is completely locked (Fig. 11). Follow
the same steps for the central and right front flap.
2.3 Insert the rear right, central and left flaps of the liner into the relevant support
seats in the helmet neck-ring area (Fig. 10). Push the flaps until they are fully
hooked onto the support.
Note: Insert helmet's left and right side vanes of between the edge of the shell
and the polystyrene foam (Fig. 10).
2.4 Hook the roll-neck eyelet to the frame fixed to the outer shell (Fig. 9), making sure
that the frame's central hole is free.
2.5 Carefully adjust the liner until it adheres well to the shell.
Note: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. In this is not the case, repeat the
steps 1.6 and 2.2.
CHEEK PAD ASSEMBLY
2.6 Insert the band and the left chin strap into the slot of the left cheek pad.
2.7 Put the left cheek pad against the polystyrene inner cheek pad and push the
padding near the 3 snap fasteners on its back in order to fasten them (Fig. 8).
2.8 Repeat these steps with the padding of the right cheek pad.
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely fitted.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Clean it with a wet cloth and allow it to dry at room temperature away from direct
sunlight.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Never use tools or equipment of any sort to carry out the steps described above.
• VISION PROTECTION SYSTEM (VPS)
The new and exclusive inner Vision Protection System (VPS) is a scratch-resistant
coated, moulded,
or up to respectively activate it or remove it from the field of vision. It is useful in all
sorts of situations, both on long journeys out of town and shorter town trips.
®
sunscreen. Its use is simple and practical: just pull it down
17