Nolan X-lite X-902 Instrucciones De Utilizacion página 25

7
8
9
Warning !
pins of the visor.
Do not loosen the adjusting screws on the hooking
B) Manually rotate upward the
visor supports on the side
mechanisms till they reach
their maximum open position
on both sides of the helmet.
(Fig. 7).
1.5.1 - Set the end part of the
visor onto a visor hooking pin
and line up its inner guides
with the mechanism supports
(fig. 8).
1.5.2 - Push the visor inside
onto the hooking pin and line
up the inner guides with the
mechanism supports at the
same time (Fig. 9).
1.5.3 - Push the visor back-
wards, sliding it on the support
until the locking pin clicks in the
hole of the visor and locks it.
1.5.4 - Repeat the steps 1.5.1,
1.5.2 and 1.5.3 on the other
side of the helmet.
1.5.5 - Pull down the visor (see
1.2) then pull it up again (see
1.1) to make sure that the sys-
tem works correctly.
- 23 -