Protecting The Environment; Technical Data - Stanley Jumpit J309 Manual Del Usuario

6. Turn the jump-starter on/off switch to the on position.
7. start the vehicle and crank the engine in 3 to 6 second bursts.
important! If the engine doesn't start within 6 seconds let the units internal battery cool for 3 minutes before
making another attempt.
8. When the vehicle starts, turn the jump-starter off/on switch to the off position.
9. Leave the vehicle's engine running.
10. Disconnect the (–) black clamp connected to the engine or chassis first, followed by the (+) red clamp that is
connected to the battery positive (+) terminal.
11. Carefully press the negative (black) jumper cable wire into the storage channel starting at the end furthest from the
clamp.
12. Clamp the negative (black) clamp onto the clamp holder.
13. Carefully press the positive (red) jumper cable wire into the storage channel starting at the end furthest from the
clamp.
14. Clamp the positive (red) clamp onto the clamp holder.
15. Charge the unit as soon as possible.
16. Make sure that the jump-starter on/off switch is turned off while the unit is being charged or stored.
using the pivoting led area light
The pivoting area light is controlled by the area light power switch on top of the light. Make sure the area light is turned
off when the unit is being recharged or stored.
using the usB socket
1. Push the UsB power button to turn the UsB port on. The UsB power indicator will light.
2. Lift up the cover of the UsB socket.
3. Plug the UsB-powered device into the UsB socket and operate normally.
notes:
This unit's UsB socket does not support data communication. It only provides 5 volts/500mA DC power to an external UsB-powered
device.
Make sure the UsB power button is in the off position when the unit is being recharged or stored.
some household UsB-powered electronics will not operate with this unit.
using the 12 volt dc power socket
This portable power source is also for use with all 12 volt dc accessories equipped with a male accessory socket plug
and are rated up to 5 amps.
1. Lift up the cover of the unit 's 12 VDC socket.
2. Insert the 12 volt dc plug from the appliance into the 12 VDC accessory socket on the unit. DO NOT EXCEED A 5
AMP LOAD.
3. switch on the appliance and operate as usual.
4. Periodically press the battery power level button to check battery status.
trouBleshootIng
unit will not charge
• Make sure the power switch is in the off position.
• Make sure the jack of the mains charging adapter is properly connected to both the unit and a functioning mains
power socket.
• Make sure the 12 VDC charging adapter is properly connected to both the unit and the accessory socket socket of
your vehicle or other 12 VDC power source.
unit Fails to Jump-start
• Make sure unit's power switch is in the on position.
•
Check that jump-starter has a full charge. Recharge unit if necessary.
• Make sure a proper polarity cable connection has been established.
usB Power Port will not power appliance
• Make sure the UsB charging port power button is in the on position.
• Check that unit has a full charge. Recharge unit if necessary.
lED Area light does not come on
• Make sure the Pivoting LED area light power switch is in the on position
•
Check that unit has a full charge. Recharge unit if necessary.
12 volt Dc accessory outlet will not power appliance
• Make sure the the appliance does not draw more than 5 amps.
• Check that unit has a full charge. Recharge unit if necessary.
EnglisH
J309EU_Manual_040512.indd 6-7
or
6
MaIntenance
This unit has been designed to operate over a long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular cleaning.
WARning: Before performing any maintenance or cleaning of the unit, unplug it from the power supply.
• From time to time wipe the unit with a damp cloth. Do not use any abrasive or solvent-based cleaner. Do not immerse
the unit in water.
• Clean the outside case of the jump starter with a soft cloth and, if necessary, mild soap solution.
• Do not allow liquid to enter the unit'. Do not operate when the battery charger is wet.
• Keep the cords loosely coiled during storage to prevent damage to the cords.

ProtectIng the envIronMent

correct disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was purchased. They can take this product
for environmentally safe recycling.
separate collection of used products and packaging allows materials to be recycled and used again. Re-use
of recycled materials helps prevent environmental pollution and reduces the demand for raw materials.
Lead acid batteries can be recharged many times. At the end of their useful life, discard batteries with due care
for our environment:
• Do not dispose of the battery in fire, as this may result in an explosion.
• Lead acid (Pb) batteries are recyclable. They must not be disposed of with household waste. The battery must be
removed and disposed of in accordance with local regulations.
• Do not short-circuit the battery terminals.
• Be aware that the battery is heavy.
• If possible, operate the appliance to run the battery down completely.
• Place the battery in a suitable packaging to ensure that the terminals cannot be short-circuited.

technIcal data

Boost ampere: 12VDC, 300A
instantaneous
Battery type: Maintenance-free, sealed lead acid, 12 VDC, 7Ah
Area light: 1 long-life white LED
UsB socket: 5VDC, 500mA
DC accessory socket: 12VDC, 5A
Mains charging adapter Input 220-240 Vac
(EU and GB models): Output 12VDC (500mA)
12 VDC charging adapter: 12 VDC
lIMIted Warranty
Manufacturer issues this limited warranty to the original purchaser of this product. This limited warranty is not
transferable and is only valid for non-commercial use. Manufacturer warrants this unit for 2 years from the date of
purchase against defective workmanship or material. It is the obligation of the purchaser to forward the unit together
with proof of purchase to the manufacturer or its representative with transportation cost prepaid. This warranty is void if
the unit is abused, handled carelessly or repaired by anyone other than manufacturer or its authorized representative.
Manufacturer makes no warranty other than this limited warranty and expressly excludes any implied warranty including
any warranty for consequential damages. This is the only expressed limited warranty and manufacturer neither
assumes nor authorizes anyone to assume or make any other obligation towards the product other than this limited
warranty.
Baccus Worldwide LLC
Weena 290
3012 NJ Rotterdam or
Postbus 819, 3000 AV Rotterdam
, 5 seconds 225A
7
4/5/2012 2:18:13 PM
EnglisHn