Preparation; Working With The Battery-Operated Clipping Machine, Charger; And Li-Ion Battery; System Set-Up - B.Braun Aesculap Econom CL Instrucciones De Manejo/Descripción Técnica

The charger GT803 is equipped with to charging bays.
Charging starts automatically as soon as the Li-ion battery is inserted in
the charging station.
The charging time depends on the charge state and capacity of the Li-ion
battery.
Charging principle
The Li-ion batteries are charged by constant current pulses.
The charge state of the Li-ion battery is monitored during charging. Mon-
itoring of the charging curve ensures that the battery is fully charged
without overcharging.
Additionally, the battery temperature and charging time are monitored as
well.
The charge status display f of the Li-ion battery has 5 LEDs. Each LED
stands for 20 % of charge volume. When the battery is charging, the LED
of the respective charging status blinks. When all the LEDs are perma-
nently illuminated, the battery is completely charged.
Charging time
Charging is stopped as soon as the maximum charging time is reached. The
charging time is approx. 70 min.
3.

Preparation

Non-compliance with the following instructions will preclude all respon-
sibility and liability in this respect on the part of Aesculap.
►
When setting up and operating the product, adhere to:
– national regulations for installation and operation,
– the national regulations on fire and explosion protection,
– operating advisories according to IEC-/VDE regulations.
4. Working with the battery-operated
clipping machine, charger and Li-ion
battery
4.1

System set-up

Connecting the accessories
Combinations of accessories that are not mentioned in the present
instructions for use may only be employed if they are specifically intended
for the respective application, and if they do not compromise the perfor-
mance and safety characteristics of the products.
4.2

Function checks

Battery-operated clipping machine Econom CL sheep shearing
►
Carry out a visual inspection.
►
Ensure that the air filter 37 is positioned correctly, see Fig. F.
►
Push the Li-ion battery 38 into the machine shaft and lock it.
►
Check the charge level of the battery: press button g, see Fig. E.
►
The charge status display f indicates the charge status.
Note
In order to prevent the lithium iron battery discharging when the machine
is not being used, the electronic connection between the Li-ion battery and
the control system for the battery-operated clipping machine is cut after
1 hour.
►
Reactivate Li-ion battery 38; press button g, see Fig. E.
All the LEDs in the charge status display f illuminate.
Charger/Li-ion battery
►
Carry out a visual inspection.
►
Prior to connecting the product to mains power:
– Check the mains power cord for any damage.
– Inspect product for possible damage (e.g. inspect contacts of the
charging bay for bent contacts)
►
Plug in mains power cord at the device socket of the charging station.
►
Plug in the mains plug at the mains power socket.
►
Place the Li-ion battery 38 in the charging bay of the charger and
charge it, see Fig. F.
4.3 Connecting the charger/Charging the Li-ion bat-
tery
Fire hazard due to battery poles shorted by fluids or
metal components!
►
WARNING Li-ion battery not inserted
Risk of injury due to damaged mains power cord!
►
Check mains power cord for any damage before
WARNING charging.
►
Arrange for any damaged mains power cord to
be replaced by the manufacturer.
Risk of injury and material damage due to damaged
Li-ion battery!
►
WARNING Prior to charging, check the Li-ion battery for
any damage.
►
Do not use or charge any damaged Li-ion bat-
teries.
5