TROUBLESHOOTING
1.
Is the power cord correctly connected to the wall outlet and the socket of the power supply?
2.
Make sure the on/off switch is in the "I" position.
3.
Check that the 24-pin mainboard connector and the 4+4-pin CPU connector are correctly connected to the mainboard.
4.
Check if the connectors of the cables are firmly plugged into the sockets of the peripherals.
5.
Pull the power plug out of the wall outlet and leave the power supply without power for approximately 10 minutes.
This will cause a reset of the protective circuits.
6.
If the system still fails to function, please contact support@sharkoon.com.
Please note: The cable connectors are designed to prevent improper connection. If the connector does not fit into the
sockets of mainboard, drive or peripheral device, please check if the connector and socket are being connected in the
correct orientation. Do not try to force a connector into a socket using the incorrect alignment, nor modify the compo-
nents, otherwise the power supply and your hardware will be damaged. The Sharkoon warranty does not cover any
damage that has been caused by improper handling.
WARNING
To prevent the risk of electric shock, do not open power supply housing. No user-exchangeable
parts inside. Refer service and maintenance to authorised Sharkoon personnel. Warranty is void
under unauthorized attempt to open the power supply housing. Suitable for indoor or office use only.
Keep the power supply away from humidity!
LEGAL DISCLAIMER
For potential loss of data, especially due to inappropriate handling, Sharkoon assumes no liability. All named products
and descriptions are trademarks and/or registered trademarks of the respective manufacturers and are accepted as
protected. As a continuing policy of product improvement at Sharkoon, the design and specifications are subject to
change without prior notice. National product specifications may vary. All rights reserved especially (also in extracts)
for translation, reprinting, reproduction by copying or other technical means. Infringements will lead to compensation.
All rights reserved especially in case of assignation of patent or utility patent. Means of delivery and technical modifi-
cations reserved.
DISPOSAL OF YOUR OLD PRODUCT
Your product is designed and manufactured with high quality materials and components, which can
be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product, it means the product is covered by the
European Directive 2012/19/EU.
Please be informed about the local separate collection system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old products with your normal household waste.
The correct disposal of your old product will help prevent potential negative consequences to the environment and
human health.
EN