Trust ACDB-7000AC Manual Del Usuario página 6

EN
ACDB-7000AC WIRELESS DOORBELL WITH PLUGIN CHIME
1. Place chime receiver
Place the chime receiver in a socket.
2. Select melody
Press the [¯] button several times to select 1 of the 5
melodies. You can select a different melody for each
transmitter.
3. Select volume level
Press the volume button [ ] several times to select 1 of
the 4 volume levels. You can select a different volume
level for each transmitter.
4. Activate learn-mode
When you have selected the desired volume level and
melody, press the [LEARN] button for 1 second to activate
the learn-mode. The learn-mode will be active for 15
seconds and the LED-indicator will blink slowly.
5. Assign Trust Smart Home transmitter code
While the learn-mode is active, send an ON-signal with any
Trust Smart Home transmitter to assign the code to the
receiver's memory.
6. Code confirmation
The LED indicator will blink fast to confirm the code has
been received. The receiver can store up to 4 different
transmission codes in its memory. The memory will be
preserved when the receiver is moved to another socket
or in case of power failure.
6
7. Affix push button
A
Apply double-sided tape to the back of the wireless
switch and stick the push button on to a flat surface, or
use screws to affix the back plate to a flat surface.
B
Slide the push button housing over the back plate and
close it. Properly closing the push button is important
to avoid leakage.
8. Single code delete
A
Press the [LEARN] button for 1 seconds to activate
the learn-mode. The learn-mode will be active for 15
seconds.
B
While the learn-mode is active, send an OFF-signal
to delete the code of a specific Trust Smart Home
transmitter.
C
The LED indicator will blink fast shortly to confirm code
deletion.
9. Full memory delete
A
Press and hold the [LEARN] button for 7 seconds until
the LED indicator starts blinking fast. The delete mode
will be active for 15 seconds.
B
While the delete mode is active, press the [LEARN]
button again for 1 second.
C
The LED indicator will blink fast shortly to confirm
memory deletion.
10. Replace transmitter battery
A
Open the battery compartment using a flat screwdriver.
B
Place a new 3V CR2032 lithium battery. The polarity
should match the symbols on the holder.