Tabla de contenido
Publicidad
QUICK START GUIDE
The following guide is an overview of the procedures for preparing your model to drive. The
complete manual for your model can be viewed and downloaded by following the link on the
cover of this manual or by scanning the QR code. Please read this entire manual for complete
instructions on the proper use and maintenance of your model.
READ THE SAFETY PRECAUTIONS
For your own safety, understand where carelessness and misuse could lead to personal injury
and product damage.
PREPARE YOUR MODEL
Install the transmitter batteries
The transmitter requires 4 AA
alkaline or rechargeable batteries.
INSTALL THE BATTERY PACK IN THE MODEL
Your model includes a 7.2V 6-cell NiMH battery pack. Install the battery
pack into the battery compartment with the battery wires facing the
front of the model. Secure the battery with the battery hold-down,
making sure not to pinch the battery wires.
Compatible batteries: 5- to 6-cell, 6.0-7.2V, 2/3A NiMH
TURNING ON YOUR MODEL
Turn on the transmitter
Always turn the transmitter on first, before
turning on the model. The transmitter's LED
will glow.
Plug the battery into the speed control
Make certain the plugs are fully engaged.
Turn on the model
Press and release the EZ-Set button on the speed control. The LED will glow red.
Note: If the LED is not red, see the Owner's Manual at LaTrax.com for more information or
contact LaTrax Customer Service.
Charge the battery pack
Plug the charger into a wall outlet. The LED on the charger will glow
green. Plug the battery into the charger. The LED will glow red,
indicating the battery is charging. Charge time is approximately 3 ½
hours. The LED will turn green when the battery is fully charged.
7
Publicidad
Tabla de contenido
