Tabla de contenido
Publicidad
BEFORE OPERATING YOUR MODEL
Check servo operation
Confirm the model's wheels turn right and left when the transmitter steering wheel is turned right
and left. The front wheels should be pointing straight ahead. If they are turned slightly, slowly
adjust the steering trim knob on the transmitter until they are pointing straight ahead.
Range test the radio system
With a friend's help, check servo operation at
the farthest distance you plan to drive the model
and confirm that there is no radio interference.
OPERATING YOUR MODEL
Avoid running your model in tall grass, deep
sand, or other conditions that severely limit the
driving performance of the model. This will strain
the power system and could cause early motor
failure. If the model becomes stuck, do
not apply throttle. Free the model before
continuing.
The transmitter has a directional antenna. For
maximum range, hold the transmitter upright
and pointed in the direction of the model.
Pointing the transmitter away from the model will
reduce radio range.
AFTER YOU RUN YOUR MODEL
Turn the model off
Press and release the EZ-Set button on the speed control.
The speed control's LED will go out.
Unplug the battery and remove it from the model
Do not store the model with the battery installed.
Turn the transmitter off
Always turn the transmitter off last, after the model has been turned off.
8
Steering
Set Button
Trim
Forward
Note: After stopping the model, return the
transmitter's trigger to neutral and push
forward to activate reverse throttle.
Brake/
Reverse
Neutral
Publicidad
Tabla de contenido
