Setup Instructions - Kathrein UFO 372/TP Manual Del Usuario

Setup instructions

The twin DVB-S2-QAM (QPSK/8PSK on QAM) transmodulator is set up using the controller on the base unit UFG 404 or
UFG 412 or UFG 412/R.
Required software version for the controller: at least version V 9.30
For setup, connect the controller to the module (contains channel units I and II).
The buttons specifi ed below apply to the controller (also see instructions for the base units UFG 404 or UFG 412 or UFG 412/R).
Note: The settings and numerical values shown below are intended as an example and do not necessarily match
the delivery status.
The desired channel unit (I or II) is selected using the "<<" or ">>" buttons.
The desired parameter is selected using the "<" and ">" buttons.
The selected parameter fl ashes in the display.
The setting is performed using the "+" and "-" buttons and where necessary using the "Change setting mode" button
The sub-menus are activated and deactivated by pressing the "Sub-menu" button
Finally, press the "M" button to save the setting in the module.
Note: If the controller is disconnected from the module without saving the settings by pressing the "M" button,
the settings originally stored in the module are reactivated.
Setting the language and interrogating the version numbers
Pressing the "F" button brings you to the System menu, where the language can be set and the version numbers interrogated.
**** System
Set language
Selection with +/-
System menu
The "+" and "-" buttons in the system menu can be used to choose between "Set language" and "Version numbers".
Pressing the "Sub-menu" button activates the sub-menu; pressing the "Sub-menu" button again deactivates it.
In the "Set language" sub-menu the "+" and "-" buttons can be used to select the desired language.
The following settings are available: German, English, French or Spanish
**** System
Version numbers
Selection with +/-
System menu
In the "Version numbers" sub-menu the data listed above can be called up.
Then press the "Sub-menu" button
The following representation shows the display after plugging in the controller:
Note: An indicator (*) fl ashes at top right during channel unit initialisation.
I 1236 MHz
27.500 MS/s
Outp. * S21
6.900 MS/s
Main menu (all symbols shown)
All manuals and user guides at all-guides.com
****
****
to deactivate the sub-menu again. Press the "F" button to exit the system menu again.
* P TP
3/4 QPSK
306.00 MHz
! 256 QAM
.
Language
English
"Set language" sub-menu
Boot loader
Controller
"Version numbers" sub-menu
.
4.00
9.30