Relay Digital Outputs (Doxx) - ECOFOREST ecoSMART e-manager Manual Instalador

2.7.

Relay digital outputs (DOxx)

The controller program allows managing up to four non-critical loads when we have electrical surplus. The four relays that enable
these loads are included in the box of the ecoSMART e-manager. The supply of each relay is independent, so that different working
voltages can be used in each of them. The following figure shows an example of the installation of the power supply of a relay.
POWER
SUPPLY
8 7 6
24 Vac
FBus BMS2
Figure 2.8. Example of power supply connection to relays of the digital outputs
Each relay allows cutting the poles (line + neutral) with a capacity of 8A / 250Vac per pole. If the equipment to be controlled
exceeds this capacity it is necessary to install an external relay.
Pay particular attention to the maximum consumption allowed by the relays. If necessary use an intermediate relay to make the
connection.
NOTE
All manuals and user guides at all-guides.com
CHiNT
NH4-2-32
J16 J17 J18
J10 FBUS1 J11 BMS2 J14 pLAN
J27
J15
pCOOEM+
J25
5
J1 J2 J3 J4
pLAN
Installer manual ecoSMART e-manager
NC
COM
NO
COIL
J19 J20 J21 J22 J23 J24
J28
J29
J26
J5 J6 J7
DI1 DI2 DI3 DI4 DI5 DI6
35
L N PE
NC : 22/12
COM : 21/11
NO : 24 / 14
NC
COM
NO
A2 A1 /