Craftsman 580.752381 Instrucciones De Uso página 23

Change Engine Oil
While engine is still warm, drain oil from crankcase. Refill
with recommended grade. See Changing Engine Oil.
Oil CylinderBore
* Removespark plug. Squirt about 1 tablespoon of clean
engine oil into the cylinder. Cover spark plug hole with
rag. Puff recoil handle slowly to distribute oil. Avoid spray
from spark plug hole.
. install spark plug. DO NOT connect spark plug wire.
Protect Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver,Model 6039, to treat
pump. This prevents freeze damage and lubricates pistons
and seals.
NOTICE You must protect your unit from freezing
temperatures.
• Failure to do so will permanently damage your pump and render
your unit inoperable.
• Freezedamage is not covered under warranty.
NOTICE PumpSaver is available as an optional accessory, it
is not included with the pressure washer. Contact your local
Searsservice center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Readand follow aii
instructions and warnings given on the PumpSaver container.
Other Storage Tips
1. DO NOTstore fuel from one season to another unless it
has been treated as described in Protect Fuel System.
2. Replacefuel container if it starts to rust. Rust and/or dirt
in fuel can cause problems if it's used with this unit.
3. Cover unit with a suitable protective cover that does not
retain moisture.
_i, WARNING Storage covers can be flammable.
o
o
DO NOT place a storage cover over a hot pressure washer.
Let equipment cool for a sufficient time before placing the
cover on the equipment.
4. Store unit in a clean and dry area.
23