How to Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown below.
Foflow these instructions to changespray tips:
1.
Pull back collar on quick-connect and pull current spray
tip off. Store spray tips in holes provided in the handle.
_i, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER exchange spraytips withoutthetriggerlockedon the
spraygun.
• DONOT twist spraytips whilespraying.
2.
Select desired spray tip:
•
For gentle rinse, select white 40° or green 25° spray
tip.
•
To scour surface, select yellow 15° or red 0° spray
tip.
•
To apply detergent, select black spray tip.
3.
Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
Usage Tips
*
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
DONOT get closer than 6 inches (15 cm) when cleaning
tires.
Cleaningand Applying Detergent
_i, WARNING ChemicalBurn Hazard.
_
Chemicals could cause bodily injury, property
_
damage or death.
• DONOT usecausticliquidwith pressure washer.
• UseONLYpressure washersafedetergents/soaps. Follow all
manufacturers instructions.
TOapply detergent, follow these steps:
1.
Pull back on collar, insert black detergent nozzle and
releasecollar. Tug on nozzleto make sure it is securely
in place.
NOTICE Detergentcannot be applied with the high pressure
spray tips (White, Green,Yellow, or Red).
2.
Prepare detergent solution as required by job.
3.
Placesmall filter end of detergent siphoning tube into
detergent container.
NOTICE Make sure the filter is fully submerged in detergent
while applying detergent.
NOTICE
Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
4.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
5.
Start engine following instructions How to Start Your
Pressure Washer.
LOWPressure
\
Useto
apply
detergent
Black
White
40°
High Pressure
D
I
D L
I
D
I
J
L
J
Green
Yellow
Red
25°
15°
0°
13