Toshiba RBC-AX23UWW-E Manual Del Propietário página 5

Wireless Remote Controller Kit
Signal Receiving Part
• The signal receiving part is attached to the
indoor unit.
• Hereinafter, all remote controller button
names are indicated with respective
symbols displayed on the remote
controller.
Example: Start/Stop button →
2
3
6
1
Emergency operation button
(See page 13)
2
Signal receiver
Receives signals from the remote controller.
3
Display lamp
Any of these lamps flashes while an error
occurs.
When an lamps flashes, see "Before Asking
for Repair Work" on page 14.
4
lamp (green)
This lamp illuminates when unit is on.
5
lamp (green)
This lamp illuminates while the timer is
reserved.
6
lamp (orange)
• Illuminates in the heating mode at the
beginning of operation or during defrosting
or when the temperature controller is
activated.
• Flashes during an error state.
The rear of signal receiving part
The following switches are provided on the
rear of the signal receiving part. For their
settings, contact the dealer from whom you
purchased the air conditioner.
• Header/follower switch
Normally, set this switch to "HEADER" to
use the remote controller as a header.
The remote controller can be used
together with the wired remote controller
4
(sold separately).
5
• Test run switch
Do not use this switch in normal operation,
1
but use for service.
• Address switches (See page 12)
Distinguish transmit signals and receive
signals.
CAUTION
• If beep is heard with the
and
heat-pump type air conditioner is used,
desired operation mode is disabled. The
same is true if the AUTO mode is
selected in a model that is not provided
with the cool/heat auto function.
• Even if you push
remote controller operation is disabled
by the central control or other means, "pi"
is heard 5 times and the button operation
is not accepted.
– 4 –
Owner's Manual
lights and the
flashing alternately while the
, or when
EN
4-EN