PerfectPower
2.2
Safety when installing the device
WARNING!
!
Never connect more than one consumer device to the inverter.
If you connect more than one device, a short circuit may occur.
CAUTION!
!
Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
Take the precautions necessary to ensure that children cannot
interfere with operation. Dangerous situations may occur which
cannot be recognised by children!
Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
Electrical cables
If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or wire bushings to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
2.3
Operating the appliance safely
WARNING!
!
Note the following basic safety information when using electrical
devices to protect against:
– Electric shock
– Fire hazards
– Injury
Do not operate the device near gas or flammable material; the
surface temperature can reach up to 60 °C.
EN
All manuals and user guides at all-guides.com
General safety instructions
19