Ice Maker; Installation Instructions; Installation Of Your Ice Maker - Silhouette Select DIM3225BLSST Guia Del Propietario

INSTALLATION INSTRUCTIONS

BEFOR USING YOUR

ICE MAKER

• Remove the exterior and interior packaging.
• Before connecting the Ice Maker to the power source, let
it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a
soft cloth.
• Attach the water inlet and outlet pipe, loosen the screw
nut, choose the function switch. (see Ice Maker
performance mode instructions)
• Before use, please make two full boxes of ice and then
dispose it to insure the ice is clean and healthy.
• When disposing your appliance, please choose an
authorized disposal site.
All manuals and user guides at all-guides.com
• Place your Ice Maker on a floor that is strong enough to
• Locate the Ice Maker away from direct sunlight and
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-
• Do not open the door unless necessary.
• Should the Ice Maker be stored without use for long
2
INSTALLATION OF YOUR
ICE MAKER
support it when it is fully loaded. To level your Ice Maker,
adjust the front leveling leg at the bottom of the unit.
sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating on the exterior of
the unit and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.`
grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an
authorized Products service center.
ATTENTION
periods it is suggested, after a careful cleaning, to leave
the door ajar to allow air to circulate inside the cabinet
in order to avoid possible formations of condensation,
mold or odors.