Folding/Unfolding Stage 2
A
B
C
F
E
B
D
F
F
E
G
1. To fold ExerSaucer ® , ALWAYS remove baby and toy
from ExerSaucer ® before folding.
A
bar(s)
With ExerSaucer ® flat on the floor, twist each leg
B
assembly
fully clockwise (the direction of the arrow)
until it stops in the position shown.
B
Fully depress one of the pedestal locking tabs
push on the leg assembly
this procedure for all four legs.
After pressing the fourth pedestal locking tab
ExerSaucer ® will fold with the tray
E
base
. Make sure all four tray locks
the base before trying to carry ExerSaucer ® .
F
Note: Make sure the legs are at the same height
adjustment or the ExerSaucer ® will bind and not fold
properly (refer to page 8).
2. To unfold the ExerSaucer ® , release the four tray
F
locks
by pulling them outward from the base
as shown.
Hold the base down with your foot, and pull the tray
upward. The tray will rotate as you pull and the legs will
lock in the upright position. The leg assemblies
lock onto the pedestals
B
Twist the tray to make sure all legs are locked properly.
IMPORTANT: Make sure all four leg assemblies
G
firmly locked onto the pedestals
10
C
then
B
; leg will partially fold. Repeat
C
, the
D
rotating toward the
F
are locked onto
B
G
.
B
G
before use.
E
,
will
are