Publicidad
Idiomas disponibles
Idiomas disponibles
Procedure - Removing the Existing Control Panel
Remember, the Doors are not shown.
•
2
Using your thumb, press UP on the face of the
•
Thermometer.
You will feel the Thermometer snap loose.
•
Pull the Thermometer away from the Control Panel.
•
Place the Thermometer in a secure place for
•
reinstallation later.
Repeat this step for each Thermometer on your Grill.
•
Remove all Control Knobs by pulling them straight
•
3
away from the Control Panel. The Knobs may be
tight and require increased effort to remove them.
Perform the following ONE Knob at a time.
•
Using a Phillips Screwdriver, remove the two #8
•
Machine Screws and Washers (if provided) and
keep the Control Knobs and Bezels in a secure
place for reinstallation later.
Reinstall the two Screws and Washers (if provided)
•
back in the location from where they were removed.
This will hold the Manifold in place until all Bezels
are removed. This is shown in the inset image.
Repeat this step for each Control Knob on your Grill
•
including your Side Burner, if your Grill is so
equipped.
NOTE - if your Grill DOES NOT have a Side Burner -
4
then this step will not apply. You may skip this step.
The Gas Manifold is connected to the Side Burner
with a Quick-Disconnect type fitting. Slide the Quick-
Disconnect back and while holding it back, pull the
Hose away from the Fitting.
1
2
© Saber Grills, LLC
All manuals and user guides at all-guides.com
3
Control Panel
CAUTION: Do not rotate the Knobs
clockwise past the OFF position
to avoid damage to the Valves.
80028080 ● 09/13/17 ● Revision 03
Printed in U.S.A.
sabergrills.com
Publicidad
