Publicidad
Idiomas disponibles
Idiomas disponibles
Procedure - Removing the Existing Control Panel
Using your Phillips Screwdriver, remove the two #8
•
5
Sheet Metal Screws from the lower tabs of the
Control Panel.
Place these Screws in a secure location . They will
•
be used to install your new Control Panel.
For this step, close the Doors on your Grill and raise
6
the Lid.
This step will require your Gloves.
Grasp the Control Panel at each end and lift it
•
straight up from the Grill. You will be disengaging
the three locking tabs that hold the top of the
Control Panel in place.
Note that there are connections on the rear of the
•
Control Panel - so do not try to completely remove
the Control Panel yet.
First - rotate the Control Panel down and let the
•
bottom of it rest on the Door Handles, as shown.
© Saber Grills, LLC
All manuals and user guides at all-guides.com
4
Lift only enough to
disengage tabs
Rotate the Control
Panel and allow it to
rest on the top of the
Doors.
80028080 ● 09/13/17 ● Revision 03
Printed in U.S.A.
Tabs
sabergrills.com
Publicidad
