Initial Start-Up - Dräger Alcotest 6000 Instrucciones De Uso

4.2

Initial start-up

When the instrument is switched on for the first time, the setup assistant opens.
This step is omitted for preconfigured instruments.
The following settings are made using the setup assistant:
 Language
 Date format
 Date
 Time format
 Time
 Measurement unit
All settings can be retrospectively changed using the menu.
NOTICE
Loss of default settings
If changing the battery takes more than 5 minutes, then the date and time need
to be reset. It is only possible to make a measurement with the time set.
4.3 Carrying out automatic breath sampling
Use a new mouthpiece for every test person.
Do not apply a high concentration of alcohol to the sensor, e.g. by rinsing
the mouth with high proof alcohol shortly before taking the measurement.
This reduces the life span of the sensor.
1. Remove the mouthpiece (order no. 68 10 690 "Standard", 68 11 055 "with
exhalation non-return valve") from the packaging.
For hygiene reasons, leave the mouth contact area protected by the
packaging until the mouthpiece is firmly fixed on the instrument.
2. Apply mouthpiece at an angle to the mouthpiece receptacle and push it into
the mouthpiece receptacle.
The ribbed marking (contact surface) of the mouthpiece points upwards.
The mouthpiece audibly clicks into place (see Page 2).
3. Completely remove the packaging.
4. Press and hold the
appears.
button for approx. 1 second until the startup screen
en
Use
21