WIMIUS T6 Manual Del Usuario página 6

Warning
1. Before using, please read the manual carefully and operate according to this
manual's instructions.
2. Do not staring or looking directly at the light because of the high brightness lamp,
especially for children.
3. When installing the projector, you should choose those adequate strength hanger
and screws, so as to avoid screw quality or rotating depth is not enough and
projector falling accident.
4. As a Class A product in a domestic environment, the projector may cause radio
interference. In this case, the user may be required to take adequate measures.
5. Due to high voltage inside, please do not open or try to repair the projector by
yourself. Please ask a professional technician to repair the projector.
6. In normal operation, the projector gets into standby mode after press the power
button on the control panel or remote control. Before disconnecting the AC power
cord, make sure the cooling fan has stopped. Do not disconnect the AC power
cord to turn o the projector, as this may cause the projector to malfunction.
7. About (remote control) Battery Note: If the battery is installed in reverse polarity
(positive and negative reversed position), then the battery will overheat and the
remote control becomes damaged. Ensure the remote control is out of children's
reach.
8. Please use the power of the projector labeled type and it is dangerous to use other
types of power supply.
9. Please use the supplied adapter to match the power supply, if you need to
change, please contact your dealer for replacement.
10. To ensure the stability and security of the power supply unit, it is recommended
to use a separate power lines with protective measures electrical outlet, which is
not allowed connecting to a variety of high-power electrical products in a line,
such as refrigerators, air conditioning, and so on.
11. Do not place this projector to moist or hot place; otherwise the projector may
break down.
12. If the projector is not used in a long time, please pull out the power cable from
the mains socket.
13. The projector vent is on the side to prevent overheating. Before use, you should
check them to ensure that there are no objects around.
14. Do not insert anything into the slit of the projector, or it may produce a short
circuit or an electric shock to your device and cause damage.
2