Greencut SRC350C Manual De Instrucciones página 58

58
SUPPORT OR STOP
Use the bracket as a guide for cutting wood into pieces of the same length, etc.
1. Hook the tip (I) at the end of the fence (G) over the end of the table (H).
2. Push the bracket clamp (J) down so that it is seated against the edge of the table.
3. Position the guide bracket as required, then turn the locking lever (K) to the fully locked position (X).
4. When cutting, hold the workpiece against the guide bracket so that the cut is straight and accurate.
G
CONVEYOR
1. Use the conveyor as a guide to cut the workpiece at a specific angle to the blade.
2. Slide the conveyor guide (L) into the slot (M) on the table.
3. Loosen the locking nut (N) and then use the scale and conveyor pointer (O) to position the conveyor at the
desired angle. Tighten the locknut.
4. When cutting, hold the workpiece against the conveyor and slide it along the table.
TABLE INCLINATION
The table can be tilted up to 50° to cut at an angle with the saw blade.
1. To tilt the table, loosen the table angle regulator lock nut (P),
set the table to the desired angle using the scale and pointer
(Q), and then tighten the lock nut firmly.
K
I
H
J
L
M
X
N
O
Q
P