Preparing For Session; Treatment Session; After Your Treatment Session - TensCare Tens One Manual Del Usuario

11.3. PREPARING FOR
SESSION
1) Before use make sure your skin is
clean and dry.
2) Place the electrode pads on the skin,
see section 8.
3) You can use your TENS for several
hours, you can attach the unit to your
belt using the belt clip.
4) You can safely lean on the electrode
pads. The sensation might change.
Warning: Ensure the TENS
One is switched OFF before
applying the electrode pads on the skin.

11.4. TREATMENT SESSION

1) To turn the unit ON, rotate one of the
control knobs clockwise until you
hear a click, the LED indicator will
light up (green colour).
When switched on for the first time,
the TENS One will automatically
select the mode N. Next time, it will
automatically select the mode you
were using the last time it was
switched off.
2) You can select from the 3 preset
modes. Details in section 7 will help
you identify the best mode and
parameters to suit you.
3) With the required
parameters selected, you can adjust
the intensity of the stimulation with
the two rotating control knobs on the
top of the unit until you reach a
comfortable level. The LCD display
shows the strength of intensity used
for each channel.
11.5. AFTER YOUR
When the timer reaches 0, the display
will flash until the device is manually
switched off.
1) To turn the unit OFF, rotate one of
2) Replace the electrode pads to their
mode and
19
Note: If the sensation becomes
uncomfortable,
intensity.
TREATMENT SESSION
the control knobs anti-clockwise until
you hear a click, the display will stop.
Then remove the electrode pads
from your skin by holding the pad
itself and gently pulling. Be careful
not to pull the wires as this may
damage them.
protective plastic shield and return
them to the re-sealable plastic bag.
Note: When
electrode pads, DO NOT PULL
ON LEAD WIRES.
reduce the
removing the