Next Level Racing F-Gt Elite Manual De Instrucciones página 8

support@nextlevelracing.com
Note: Recess holes to
be on outside
L
L
09: Install corresponding "T" Plate on left and right vertical extrusions with laser engraved lines facing the plate inward
Note: Angle towards rear of
cockpit like image shown
10: Bolt right post to the right base member using T-Nuts previously installed in step 1b
11: Repeat step 10 on the opposite side
8 X M8 35mm bolt
8 X M8 washer
R
R
Note: Parts are labelled for
left and right side application
4 X M8 countersunk bolt
4 X M8 countersunk bolt
14
PARTS
12: Install T-Nuts to the inside channels of the wheel posts (red dots placement)
PARTS
13: Install felt pads (green) to wheel plate ends to avoid scratching when adjusting, then bolt the wheel plate to wheel
posts using T-Nuts previously installed in step 12
PARTS
14: Install 2 x T-Nuts into front channel of the wheel post and repeat on other side (red dots placement)
Video Instruction: bit.ly/nlrbuild
4 X M8 regular T-nut
4 X M8 16mm bolt
4 X M8 washer
4 X sticky felt pads 10mm x 90mm
Felt pads
Note: Use level provided. Wheel plate
must be kept flat and level during installation
to avoid skewing.
4 X regular t-nut
15
PARTS
PARTS
PARTS