Emc - TensCare Sonic Stim + Instrucciones De Uso

11.0

EMC

The device needs
compatibility (EMC) and needs to be installed and put into service according
to the EMC information supplied in this manual.
Care must be taken when operating this device adjacent to or stacked with
other equipment. Potential electromagnetic or other interference could
occur to this or other equipment. Try to minimize this interference by not using
other equipment in conjunction with it.
The performance of the device was determined to be essential performance.
This device has been thoroughly tested and inspected to assure proper
performance and operation.
Table 1
Guidance and manufacturer's declaration – electromagnetic emissions
The Sonic Stim + device is intended for use in the electromagnetic
environment specified below. The customer or the user of the Sonic Stim +
should ensure the device is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
emissions
IEC 61000-3-2
Voltage
fluctuations /
flicker
emissions
IEC 61000-3-3
special precautions
Compliance
Group 1
Class B
Class A
Complies
regarding
Electromagnetic environment
guidance
The Sonic Stim + device uses RF energy
only for its internal function. Therefore,
its RF emissions are very low and are
not likely to cause any interference in
nearby electronic equipment.
The Sonic Stim + device is suitable for
use in all establishments including
those directly connected to the public
low-voltage power supply buildings
used for domestic purposes.
23
electromagnetic