TensCare Sonic Stim + Instrucciones De Uso página 26

Table 2
Guidance and manufacturer's declaration – electromagnetic immunity
The Sonic Stim + device is intended for use in the electromagnetic
environment specified below. The customer or the user of the Sonic Stim +
should ensure the device is used in such an environment.
Immunity Test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-
11
Power
frequency
(50/60 Hz)
magnetic
field
IEC 6061 test Compliance
level
±8kV ±8kV
contact contact
±15kV air ±15kV air
±2kV for ±2kV for
power power
supply lines supply lines
±1kV for ±1kV for
input/output input/output
lines lines
±1kV line(s) ±1kV line(s)
to lines to lines
±2kV line(s) ±2kV line(s)
to earth to earth
<5% U <5% U
T
(>95% dip in dip in U
U ) for 0.5 0.5 cycle
T
cycle 40% U 40% U
T
(60% dip in dip in U
U ) for 5 5 cycles 70%
T
cycles 70% U
U (30% dip in U
T
in U ) for 25 cycles <5%
T
cycles <5% U
U (>95% dip in U
T
in U ) for 5 seconds
T
seconds
30 A/m 30 A/m
Electromagnetic
environment guidance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Mains power quality
should that of a typical
commercial or hospital
environment.
Mains power quality
should that of a typical
commercial or hospital
environment.
(>95% Mains power quality
T
) for should be that of a
T
typical commercial or
(60% hospital environment. If
T
) for the user of the device
T
requires continued
(30% dip operation during mains
T
) for 25 power interruptions, the
T
device should be
(>95% dip powered from an
T
) for 5 uninterruptible power
T
supply.
Power frequency
magnetic fields should
be at levels
characteristic of a
typical location in a
24