J4C KIT BSR 20 Instrucciones Montaje página 12

MOUNTING INSTRUCTIONS BSR KIT 140/300
ENGLISH ENGLISH ENGLISH
- - -
6. Place the battery supports (B), as per picture (Fig. 7A & 7B).
7. Fix the battery supports (B), with the sheet metal fixing screws (D) (Fig. 8A & 8B).
8. Connect the battery cables to the BSR PCB (A), as per (Fig. 8C).
9. Put both battery cables (C) together with the plastic clamp (E) (Fig. 8D). Cut the remaining part of the
plastic clamp (E).
10. BSR Configuration NO or NC (Fig. 9):
NC (normally close) SELDIR jumper ON.
NO (normally open) SELDIR jumper OFF.
11. Carefully replace the cover and be sure that the joint is correctly lodged in its place. See (Fig. 10).
Be sure that any cable is not trapped between the cover and the body.
12. Fix the 8 screws, between the cover and the body. See (Fig. 11).
13. Reassemble the hand wheel and fix it with the screw. See (Fig. 12).
14. Fill in the blanks of the document inside the BSR KIT and send it back to the supplier, via fax or mail.
Now, the actuator is ready to work.
We strongly recommend to put the power on, send the actuator to an intermediate position and
check that, after putting the power off, the actuator goes to the pervious set-up position (NC or NO).
BSR 140/300
03