J4C KIT BSR 20 Instrucciones Montaje página 4

MOUNTING INSTRUCTIONS BSR KIT 20/85
ENGLISH ENGLISH ENGLISH
- - -
6. Place the battery pack (C) on the lower battery support (B) (Fig.7B). The battery cables should
remain on the bottom part. Put the cables, as shown in the picture (Fig.7A).
7. Connect the battery cables to the BSR PCB (A), as per (Fig.7C).
8. Place the upper battery support (D) (Fig.8A) and fix it to the columns of the lower battery support
(B), by using the Plastic fixing screws (F) (Fig.8B & 8C).
9. BSR Configuration NO or NC (Fig.9):
NC (normally close) SELDIR jumper ON.
NO (normally open) SELDIR jumper OFF.
10. Carefully replace the cover and be sure that the joint is correctly lodged in its place. See (Fig.10).
Be sure that any cable is not trapped between the cover and the body.
11. Fix the 6 screws, between the cover and the body. See (Fig.11).
12. Reassemble the hand wheel and fix it with the screws. See (Fig.12).
13. Fill in the blanks of the document inside the BSR KIT and send it back to the supplier, via fax or mail.
Now, the actuator is ready to work.
We strongly recommend to put the power on, send the actuator to an intermediate position and
check that, after putting the power off, the actuator goes to the pervious set-up position (NC or NO).
BSR 20/85
03