Descrizione Generale - RISCO Group RWX73F Manual De Instrucciones

Ocultar thumbs Ver también para RWX73F:

Guía de instalación rápida (2 páginas)

Manual (16 páginas)

Contenido

página de 17

/ 17
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Step 3: Selecting the Mounting Location

1. Select a location for best communication quality and near the intended wired detector. It's

recommended to place the unit at the highest possible position.

2. Temporarily attach the unit to this point using two-sided adhesive tape.

3. Generate an alarm signal (by momentarily opening or closing the input terminals) and verify

that the receiver has received the signal. If the alarm signal is not detected, reposition the

transmitter and try again.

Step 4: Mounting (Fig. 3 -- Fig. 6)

1. Detach back of transmitter from the back bracket (Fig. 3A). At mounting location note the

alignment marks for both components (Fig. 3B), and then install accordingly using 2 mounting

screws and back tamper screw (Fig 3C).

2. Detach magnet casing (Fig. 4A) and install with mounting screws (Fig 4B).

3. Optionally, mount spacer(s) for transmitter and/or magnet as required (Fig. 6), positioned

between the back bracket and the mounting surface.

NOTES:

• It's best to mount the transmitter on the non-moving part (door/window frame), and the

magnet on the moving part.

• Spacers are purchased separately (see table above).

• Align the marks on the magnet and transmitter cases (Fig. 5).

• For installations on wood or alloy, the maximum distance for normal operation is 10 mm (1

cm), while for metal ferromagnetic materials (such as iron) it is 5 mm (Fig. 5).

Step 5: Defining Parameters

These parameters can be deﬁned for each channel from the control panel:

Parameter

Supervision

LED Enable

Magnet

Alarm Hold

Termination

Response

Anti-sabotage magnet

Shutter Pulse

* Channel 2 termination defined as Shutter