General Information - Stanley FATMAX FMEG225VS Traducido De Las Instrucciones Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 54
ENGLISH
(Original instructions)
Grinding
Surface grinding with grinding wheels
Allow the tool to reach full speed before touching the
u
tool to the work surface.
Apply minimum pressure to the work surface, allowing
u
the tool to operate at high speed. Grinding rate is
greatest when the tool operates at high speed.
Maintain a 20˚ to 30˚ angle between the tool and work
u
surface.
Continuously move the tool in a forward and back
u
motion to avoid creating gouges in the work surface.
Remove the tool from work surface before turning tool
u
off. Allow the tool to stop rotating before laying it down.
Precautions to take when sanding paint
Sanding of lead based paint is NOT RECOMMENDED
u
due to the difficulty of controlling the contaminated dust.
The greatest danger of lead poisoning is to children and
pregnant women.
Since it is difficult to identify whether or not a paint
u
contains lead without a chemical analysis, we
recommend the following precautions when sanding
any paint.

General information

Helpful hints
Hold your angle grinder with one hand on the body and
u
the other hand firmly around the side handle (12) as
shown in Fig E.
Always position the guard so that as much of the
u
exposed disc as possible is pointing away from you.
Be prepared for a stream of sparks when the disc
touches the metal.
Maintain an angle between the disc and work surface
u
(Fig D) of approximately 30° when grinding and 10°-
15° when sanding (Fig D) for best tool control, material
removal, and minimal loading.
Caution! Use extra care when grinding into a corner as a
sudden, sharp movement of the grinder may be experienced
when the wheel contacts a secondary surface.
Warning! Always wear eye protection while operating this
power tool.
Pop-off brushes
The motor will be automatically shut off indicating that the
carbon brushes are nearly worn out and that the tool needs
servicing. The carbon brushes are not user-serviceable.
Take the tool to an authorised Stanley Fat Max repair agent.
Maintenance
Your Stanley Fat Max corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance.
10
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
u
from the interior (when fitted).
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the new
u
plug.
Connect the blue lead to the neutral terminal.
u
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13 A.
Troubleshooting
Problem
Possible cause
Unit will not
Cord not plugged
start.
in.
Cord or switch is
damaged.
Possible solution
Plug tool into a
working outlet.
Have cord or switch
replaced at a Stanley
FatMax service center
or authorized
servicer.)

Publicidad

Tabla de contenido
loading

Tabla de contenido