Publicidad
Idiomas disponibles
Idiomas disponibles
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the Red wire to the accessory wire.
Note: If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2) Red
wires on the AX-ADFD02 harness as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If the aftermarket radio has a mute wire and the vehicle is equipped with SYNC, connect the
Brown wire to it. If the mute wire is not connected, the radio will turn off when SYNC is activated .
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (5) wires, they will not be used in this application:
Blue/White, Green, Green/Black, Purple, Purple/Black
All manuals and user guides at all-guides.com
CONNECTIONS TO BE MADE
From the AX-ADFD02 harness to the aftermarket radio:
12-pin pre-wired ASWC-1 harness:
DIN jack:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2) Red wires to
accessory power.
• Connect the Blue wire to the power antenna wire.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• If the vehicle is equipped with SYNC, and desired to be retained, connect the Red and White
RCA jacks labeled "RSE/SYNC/SAT" to the audio AUX-IN jacks.
• If the vehicle is equipped without SYNC, and the AUX-IN jack is desired to be retained,
connect the Red and White RCA jacks labeled "FROM 3.5" to the audio AUX-IN jacks.
This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1 will be
used, please refer to the ASWC-1 instructions for radio connections and programming. Disregard
the harness that comes with the ASWC-1.
The DIN jack is to be used with the optional AX-LCD (sold separately) to retain SYNC information.
Continue to Installing & Programming the AX-ADFD02
REV. 6/27/2018 INSTAX-ADFD02
3
Publicidad
